![]() var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function ‘void hardStop()’:ĭFMoco:1017:16: error: ‘stopMotor’ was not declared in this scope ![]() ![]() var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function ‘void setupMotorMove(int, int32_t)’:ĭFMoco:1005:50: error: ‘calculatePointToPoint’ was not declared in this scopeĬalculatePointToPoint(motorIndex, destination) var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function ‘void updateMotorVelocities()’:ĭFMoco:922:14: error: ‘hardStop’ was not declared in this scope var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function ‘void loop()’:ĭFMoco:873:29: error: ‘updateMotorVelocities’ was not declared in this scopeĭFMoco:875:26: error: ‘processSerialCommand’ was not declared in this scopeĭFMoco:887:23: error: ‘nextMessage’ was not declared in this scopeĭFMoco:901:28: error: ‘sendMessage’ was not declared in this scope var/folders/2d/0b58mqnx2ybfqvbnj50b57yr0000gn/T/arduino_modified_sketch_626896/DFMoco.pde: In function ‘void setup()’:ĭFMoco:573:31: error: ‘setPulsesPerSecond’ was not declared in this scopeĭFMoco:647:20: error: ‘sendMessage’ was not declared in this scope Other than the board selection I’ve made in Arduino though I don’t think this is hardware related…I’m just trying to verify the sketch and getting the error below. I’m using an Arduino Uno with CNC shield 3. ![]() I’ll look at this while the dancers dance I’m just picking the kids up and then it’s ballet time. I only see like six lines at a time in Arduino and now seeing it all laid out looks like a lot of repeat stuff in here. I feel like I should read this through again before posting.
0 Comments
Leave a Reply. |